Aisi E 1- Volume Ii- Part Vii Anchor Bolt Chairs -

The outstanding leg of the chair angle acts as a cantilever. The anchor bolt’s tensile load, applied at the bolt hole (typically centered on the leg), creates a bending moment at the angle’s heel (the weld line to the base plate). Part VII provides a clear flexural strength equation based on plastic section modulus, acknowledging that cold-formed angles can develop their plastic moment capacity if compactness limits are met. This prevents the angle leg from simply folding upward under tension.

This is the most cold-formed-specific check. The chair angles are bolted or welded to the column’s thin web. Under uplift, the chair pulls outward, placing the web in transverse tension. Part VII requires checking the web for net-section rupture at the bolt holes (if bolted) or gross-section yielding at the weld toe. The standard explicitly accounts for shear lag effects when the load is transferred only through a portion of the web, a phenomenon dominant in thin-gauge members. aisi e 1- volume ii- part vii anchor bolt chairs

In the architecture of light steel framing, the connection between a cold-formed steel (CFS) column and its concrete foundation is a nexus of complex forces. While the column efficiently transfers axial and lateral loads down its slender web, the anchor bolt must translate these forces into the mass of the footing. This interface, however, is not a simple meeting of steel and concrete; it is a zone of stress concentration, eccentricity, and potential failure. Recognizing this critical juncture, the American Iron and Steel Institute’s Standard for Cold-Formed Steel Framing – Design (AISI E 1) dedicates Volume II, Part VII to a seemingly humble yet structurally vital component: the anchor bolt chair . The outstanding leg of the chair angle acts as a cantilever

However, without standardized guidance, chairs were historically over-welded, under-designed, or ignored in calculations. Part VII rectifies this by treating the chair not as accessory steel but as an integral part of the CFS assembly. It defines the chair’s geometry (angle legs, thickness, weld pattern) and, crucially, mandates that the chair’s resistance be no less than the design strength of the anchor bolt itself. This “capacity matching” principle prevents a brittle chair failure before a ductile bolt yields. The technical heart of Part VII lies in its prescriptive yet rational design checks. The standard requires the engineer to verify three distinct limit states: This prevents the angle leg from simply folding