Digi Sm-90 User Manual -

in Z mode and adjust the specific "SPEC" settings (e.g., SPEC 001 for price vs. weight). Maintenance and Calibration Calibration

: To connect via Ethernet, the scale's IP must be on the same submask as the PC (e.g., if the PC is 192.168.0.XXX , the scale should be configured between for the final digits). Programming and Operation Accessing Modes

Open the side compartment and remove the old label roll core. Insert the new roll, ensuring it slips the bar rather than going under it. Digi Sm-90 User Manual

: Place the scale on a flat, stable surface. Ensure the power supply is connected correctly. Loading Labels

: Press specific key combinations (often the "Z mode" or "Mode" key) to switch between registration and programming modes. Programming PLUs Program Mode Use the keypad to enter the PLU (Price Look-Up) number. Input the item name, unit price, and weight settings. to save the entry. Changing Settings in Z mode and adjust the specific "SPEC" settings (e

: Place a known calibration weight on the scale and enter calibration mode via the internal service switches to adjust readings for accuracy. Troubleshooting Inconsistent Readings : Ensure the scale is level and recalibrate if necessary. Label Errors : Check the gap sensor calibration if labels are not printing or feeding correctly.

: Keep the device away from extreme temperatures and moisture to prolong its lifespan. Compatible Supplies typically uses direct thermal labels. Common sizes include: Digi Scales Sm 90 Manual - CLaME Programming and Operation Accessing Modes Open the side

: For standard changes like price or weight (Barcode) setup, enter

Align the paper correctly with the small red adjuster before closing the mechanism Connectivity interfaces for PC communication. IP Configuration