Logixpro Dual Compressor Exercise 2 · Confirmed & Working

In LogixPro’s “Dual Compressor Exercise 2,” the goal was simple: maintain 90–100 PSI with two compressors, handle duty cycling, and prevent both from running simultaneously for too long to avoid overload. The twist? A random “fault” could disable one compressor, forcing the other to handle the load within strict time limits.

“You just passed Exercise 2 with a gold star,” said the plant manager, handing her a bottle of water.

The plant floor at Apex Bottling was a cathedral of stainless steel and hydraulic hiss, but its heart was pneumatic. Two massive air compressors, Titan and Atlas, squatted in the corner, responsible for breathing life into the filling heads, capping machines, and labeling jets. If the air pressure dropped below 90 PSI, the entire line screeched to a halt. If it dropped below 80 PSI, safety interlocks would fire, locking the plant down entirely. logixpro dual compressor exercise 2

When the maintenance crew finally replaced Titan’s fan at 4:00 PM, Maria collapsed into a rolling chair. On the HMI, the pressure trend showed a near-perfect line at 88 PSI, with only one brief dip to 81.5 PSI.

That Tuesday, the thermometer on the mezzanine read 104°F. Titan’s cooling fan seized at 2:17 PM. By 2:22, its discharge temperature alarm screamed red on the control panel. The compressor didn't stop—it just kept churning, heating the air to 190°F, expanding it like a furious ghost. The pressure at the receiver tank began to drop. In LogixPro’s “Dual Compressor Exercise 2,” the goal

She hit start again.

Maria’s fault wasn’t random. It was molten metal and fried bearings. “You just passed Exercise 2 with a gold

In the LogixPro simulation, you had ladder logic timers: T4:0 for the “minimum run time” and T4:1 for the “anti-cycle delay.” Maria had no time to program. She had to become the PLC.

Atlas roared to life. Pressure stabilized at 96 PSI. For thirty seconds, Maria breathed. Then the production line kicked into high gear—three cappers firing at once, a purge cycle on the filler, and a labeler changeover. The pressure cratered to 85 PSI.

Maria stared at the LogixPro window still open on her laptop. The virtual pressure gauge was steady at 95 PSI. The virtual “Dual Compressor Exercise 2” completion banner flashed green.

At 2:30, Maria Chen, the shift electrician, pulled up the LogixPro simulation on her laptop—the training software she’d mastered years ago. But this wasn’t a classroom exercise. This was Exercise 2 for real.